Hey everyone,
I'm working on my first project (a snes laptop) and it's coming along great. I thought I was in the winning stretch opening up the psone screen, and im getting rid of the 5 screws holding down the board only to find out whoever put it together stripped the hell out of the last screw. I have no clue how to remove it without damaging the board! Does anyone have any advice?
Thanks in advance!
Psone screw issue
Moderator:Moderators
- gamax92
- Posts:289
- Joined:Sat Aug 21, 2010 4:06 pm
- Location:Inside My Nintendo 64 Ram. (Dont Turn It Off!)
- Contact:
Re: Psone screw issue
The only way to get a stripped screw off is to use a drill. But be very very careful. Could you post a picture of the screw first or a diagram.
I DONT CARE ABOUT POST COUNT.
#DCE1E5 #ECECEC
I DONT CARE ABOUT POST COUNT.nevermind1534 wrote:By, I cringe every time I see a post by you, because of the immense number of useless comments that seem to be there for no reason other than to up your post count.
#DCE1E5 #ECECEC
-
- Posts:9
- Joined:Mon Jul 19, 2010 8:50 am
Re: Psone screw issue
It's ok now, I figured out how to get the screen out. Thanks so much though, it means a lot! I'll post pics when it's all done!
- HotDog-Cart
- Portablizer
- Posts:3804
- Joined:Sat Jul 16, 2005 12:07 pm
- PSN Username:Lythinca
- Steam ID:scythe_king
- Location:Your IP Address, Connecting...
- Contact:
Re: Psone screw issue
You could have also; melted a bic pen so the plastic goes around ther screw. Wait for it to harden, apply force...and unscrew.